Water conservancy revetment slope mold manufacturers of building materials, mold mold factory in Baoding Lunda slope mold plastic products, so that when we should be stored in the storage in a dry place, at the same time to ensure that the moderate temperature of the mold around and away from heat sources. Usually impossible to say to each mold is placed on the ground, in order to save space, sure to slope mold stack up, but there are restrictions on the stack height. After slope mold use for a long time, be sure to grind the edge, but also for degaussing After grinding edge. While the related detailed inspection and maintenance records, this will help in time to find the root cause of problems that occur when there is a problem in and processed and resolved. In addition to regularly check the test more easily damaged parts, they often check the connection position if there are loose fasteners phenomenon, the timely replacement of damaged parts. BINDER parts need special attention, this part also in the process of using more prone to injury, found the problem to be in time, can not be repaired must be replaced immediately. Slope mold has high brightness, high toughness, deformation, easy to mold, low breakage rate and other characteristics, mainly used in the production of high-speed mold slope revetment bricks, cement embankment slope protection brick use, into the concrete in the mold box vibration molding, dry natural coagulation After removal of the mold can be used. Do not be too compare prices, buy cheap die than to buy durable die, thus reducing the risk of product failure. Crushed material back to do the mold, there will be a lot of black spots on the surface, not muddy bright, large deformation afterburner. The appearance of the mold to be fine, do not have too much flash burr pin and knife marks on the mold appearance.